Skip to end of banner
Go to start of banner

iButton/Buzzer Driver Guide

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 7 Next »

The iButton is a compact, durable and waterproof stainless-steel device comprising of two components: the reader and the fob.  The components are allocated in Smartrak to a vehicle and an employee. This allocation facilitates the driver identification process.  The reader is wired to the vehicle and the iButton fob is carried by the employee. The fob is small enough to easily attach to a key ring and includes a magnetic holder that secures the device to its reader. The driver is required to connect the fob to the reader when they get into the vehicle before they start driving. 


Access vehicle with your iButton

iButton/BuzzeriButton Fob                                                          

                                              

   iButton Receiver

BEFORE turning the vehicle Motor on, read and follow these instructions.

 

  • Turn the ignition on, until the motor is running.


  • Insert your uniquely programmed iButton Fob into the iButton Receiver, this will disable the buzzer.


  • Leave iButton on the reader.


  • Operate vehicle as usual.


  • Turn the ignition off when vehicle is no longer in use and remove the iButton from the reader.


The iButton Fob must be attached to the iButton Receiver after the motor is running.


The buzzer will sound if these instructions are not followed.

Self Help | Service Desk | Service Desk Help | Knowledge Base | Trouble shooting | Smartrak Portfolios




  • No labels