Check In Prompt - Private Use Percentage

The simplest way to configure prompts is to access the cabinet from your computer's browser using the IP address, followed by :5000. Eg. 192.168.0.3:5000. You can then use your computer's keyboard to key in the wording for the prompts. Please note that this functionality was disabled in 3.0.29, we are looking to remedy and re-enable this in the next release, which will be in due course.

Please note: You will need to reboot the cabinet via System --> Reboot after changing any prompts.

Open

• If you are unable to find an answer to your question in here please log a support request via the Smartrak Service Desk